Downhole measuring system Triol ТМ01–10
TM01-10 purpose is to measure well parameters and electric motor temperature and then transmit the data to VSD controller. TM01-10 allows replacing the ground or submersible parts without efficiency loss, correctness, and accuracy of measurements of the whole system. TM01-10 is optimized and fully complies with the requirements of ETT6.0. It is possible to connect additional equipment with weight up to 5 tons. Submersible blocks provide operation in conditions of high pressure and temperature. The pressure sensors with a sapphire substrate are reliably protected by a titanium plate. The immunity of the system is 600V 50Hz and 1kV 100Hz.
- formation fluid temperature and pressure close to the ESM;
- motor oil temperature near stator windings;
- RMS value of ESM vibrational acceleration in the X, -, Y- and Z-planes;
- insulation resistance in the circuit “AC voltage step-up transformer (ACVOT)”- submersible cable – ESM”.
|Intake Fluid Pressure||+||+||+|
|Discharge Fluid Pressure||–||+||–|
|Intake Pump Pressure||+||+||+|
|Discharge Pump Pressure||–||+||+|
|Intake Pump Temperature||+||+||+|
|Discharge Pump Temperature||–||+||+|
|Intake Fluid Temperature||+||+||+|
|Discharge Fluid Temperature||–||+||–|
|Max depth||13 125 ft||11 485 ft||11 485 ft|
|Stainless Steel (or with corrosion resistant coating)||+||+||+|